strange issue

vreedijk

11 July 2008 13:29

Hi ,

I have a Motec m800 on a evo 7 with 6 speed gearbox . not a PnP board
I tune this car with a map and inlet temp.
i use the delco 300kpa map sensor .

What i get is when i drive in the first 5 gears i can go futher then 1.7 bar and even 2 bar boost .
But when i drive in the 6 gear i get errors in the ecu on the MAP and TP sensor when i go higher then 1.7 bar .Also the map sensor dont read higher then 1.7 bar so 270 kpa .

i have checkt the +5v to the map sensor and tps sensor and this is good .

i hope that someone can help me .

thanks ,
Wouter

Related to

• Forum Archive

0

• 

  figgie

  11 July 2008 15:24

  One question

  MAP sensors, Where is it receiving its reference from? Is the line also supplying pressure reference to another part (wastegate, blow off valve, brake booster etc)?

  0
• 

  vreedijk

  11 July 2008 20:36

  its coming direct from the inlet manifold .

  Wouter

  0
• 

  vreedijk

  13 July 2008 07:57

  Maybe i did something wrong with wiring .

  but i only found one +5v wire on the Motec M800 ( pin A2 )
  And when i see the small Delco map sensor wiring its shows for the M8 +5v wire on pin A12 but this is a +8v wiring for the hall sensors .
  So i dont used these but strange that this is on the wiring for the delco or would a M8 versie not be the M800 ?

  have no one ever have this problem ?

  And what would be a good 5 bar map sensor for the Motec ?

  Wouter

  0
• 

  vreedijk

  14 July 2008 13:07

  Thanks people for the support :evil: , i found the problem .

  Wouter

  0

Please sign in to leave a comment.