SKM Knock Sensor Position - Inline 6 Motor
I'm going to be using an M800 and SKM with my 7M-GTE motor.
The motor has three position for a knock sensor, the middle one us used by the N/A version of the motor which only ran a single knock sensor and the front and rear positions which are used by the turbo version which ran two knock sensors.
As I am restricted to using a single sensor with the SKM is there a particular position on the block I should be using and any suggestions for sensor type?
-
Just use a single and adjust gain and offset for each cylinder.
0 -
Thanks for the advice.
Which position on the block should I be mounting it, front, rear or middle?0 -
Any, the gain and offset make up for mounting position, but best bet would be a central location. If the sensor is mounted between 3 and 4 you may end up with a gain table that looks like this-#1 1.04 #2 1.01 #3 .98 #4 .98 #5 1.01 #6 1.04. It doesn't always end up symmetical and even, sometimes the correct gain can seem weird.
0 -
Thanks
That makes sense especially seeing as Toyota used the centre position for the N/A which ran a single knock sensor.
I was going to use a GM blade type sensor instead of the standard Toyota piezo type or whatever it is0 -
You would be better off using the Toyota sensor as its characteristics will be matched to the engine.
0 -
I've been told that once you bore the motor the harmonics change and it isn't as effective plus its such an old sensor the newer GM one would work better as its a different style of sensor
0 -
Better yet is the Bosch 'wideband' unit. VW/Audi etc.
0 -
I'll have to look into that, how does it mount to the block?
0 -
8mm stud mount I believe, its been awhile.
0 -
Yep, 8mm stud/bolt mount. If your block has 12mm threaded holes, you can get an 12mm to 8mm stud adaptor - Toyota Australia part 90126-08039
0 -
Thanks for the help guys, now have a Bosch knock sensor sitting on my motor and most of the Milspec engine harness completed
0
Please sign in to leave a comment.
Comments
11 comments